![]() ![]() If required cell references will be flatted. All selected elements will be deleted after calling this feature. Selected cell references will be ignored. The complete cell will be cropped with selected shapes. All circles will be added to the active layer. As a result, the center of each circle is the pole of inaccessibility of a shape. The feature adds the biggest possible circle inside any selected shapes. This feature will detect such double shapes and delete all copies except one in the current cell on all layers. Overlapping rectangle, may be non-orthogonal orientatedĮlements identical in its shapes and its layer are impossible to see in the main display and often only to be recognized by the select counter. There are four diferent types of resulting shapes: You will be prompted to enter width and spaces of the mash. With this function, you can convert polygons and boxes to a mesh. For an unused area, a mesh will be used to achieve this. In printed Circuit Boards (PCB) often a good balance between metalized and blank areas is required. The outer outline and the outline of holes can be moved to separate layers. In that case please split the shapes before using the cut feature. If the chosen parameter would require more than 20.000 slots, no modifications are made as the resulting polygons will no longer be handable afterward. ![]() All required parameters can be set in a dialog. This feature does such slot insertion for all selected shapes. To reduced stress in wide metal areas, small slots are inserted. ![]() (introduced with release 20220419)įilm stress can be a technology problem for fabrication. When you export to GDSII or CIF, this layer will be exported as that GDSII or CIF layer. layer, you can set a default wire width and end/join style. The bow is detected and replace with a bow with more vertexes. Better than freeware (although Layout Editor looks pretty good) But any of them would work just fine (except for Magic, maybe). While an reduction can be done with the Remove Small Edges feature, this feature can be used to increase the resolution. The required resolution can differ in different application. In the electronik design area bows are commonly handled as polygons with a certain resolution describing the bow. if only some vertexes of a shape should be modified, select just these vertexes with PointSelectMode,.select shapes which should be modified,. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |